intdash Terminal System#
Terminal System v1.22.0
- 1. Introduction (Terminal System)
- 2. Terminal System Quick Start - Setup from the configuration PC
- 3. Connect to the network
- 4. Configure the information needed to connect to the server
- 5. Measurement
- 5.1. Check the status of the intdash service ([intdash] > [Status])
- 5.2. Configure settings for sending data to the server ([intdash] > [Sending / Receiving])
- 5.3. Manually start/stop the measurement ([intdash] > [Status])
- 5.4. Make the measurement start automatically when the power is turned on ([intdash] > [Status])
- 6. Retrieve data from the devices (device connector)
- 7. Filtering and sampling
- 8. Transmit stored data
- 9. Check the event log
- 10. Other settings and operations
- 10.1. Set the display language and time zone for the settings screen ([Preferences]).
- 10.2. Confirm/change the name of the Terminal System ([System]).
- 10.3. Update Terminal System software ([System])
- 10.4. Check system information such as CPU usage and storage usage ([Hardware]).
- 10.5. Change the password to access the settings screen ([Basic Auth]).
- 10.6. Configure settings for saving RAW data ([intdash]>[RAW Data]).
- 10.7. Directly edit the configuration file
- 10.8. Get remote support
- 11. Troubleshooting / Frequently asked questions
- 12. Contact us
- 13. Appendix: Display Software for Terminal System