intdash Edge Agent Developer Guide
intdash Edge Agent Version 1.24.0
Table of contents
1. Introduction
2. Get started
3. Change settings
4. Add your own Device Connector
5. Contact Us
6. Appendix
intdash Edge Agent Developer Guide
»
intdash Edge Agent Developer Guide
intdash Edge Agent Developer Guide
ΒΆ
Table of contents
1. Introduction
1.1. What is Agent?
1.2. Main features
1.3. System requirements
1.4. System configuration
2. Get started
2.1. Installation
2.2. Files to be installed
2.3. Start and stop the Agent
3. Change settings
3.1. Edge information setting
3.2. Settings for using the pre-installed Device Connector
3.3. Settings related to sending and receiving of data
3.4. Settings for sending timing (filtering on the sender's side)
3.5. Settings related to saving RAW data
4. Add your own Device Connector
4.1. Configure to use your own Device Connector
4.2. Write to FIFO from Device Connector
4.3. Read data from FIFO
4.4. Automatic startup and termination of Device Connectors
5. Contact Us
6. Appendix
6.1. Base time
6.2. Filter at the sender's side
6.3. RAW data
6.4. Retransmission data
6.5. FIFO data format used between Agent and Device Connector
6.6. All settings for Agent
6.7. Agent logs